Rustic Table Lamps – If you are tired of buying in the retail table lamps, consider making your own.
Screw the 1 foot long section of copper pipe into the copper pipe flange. These flanges are flat, heavy and round and have a hole to screw in the tube in the middle. Rustic Table Lamps are usually used for the connection pipe to planar surfaces. Make sure the copper pipe fits well in the flange — pick up the mounting of the tube and shake vigorously. It should not be litigant or noise. You can pick up copper pipes and flanges at your local iron trade.
Plug in the plug at the end of your Rustic Table Lamps cord at the top of the tube. Slide down through the tube and out through the bottom of the flange. As you sit down in the congregation, it will lean aside due to the cord. The wire should fit in this curve and allow collection to be flat. Press the light on the top of the copper pipe firmly in the tube — approximately the u00BD of the socket should be visible above the edge of the copper pipe. Remove the socket from the tube, run a string of glue around the inner edge of the tube and replace the socket in the tube. The glue should put for an hour.